Batch 1: 6

ENGTP

ENTREPRISE NATIONALE DE GRANDS TRAVAUX PETROLIERS

DIRECTION ENGINEERING

Département Procurement

BP 09 Zone Industrielle de Réghaia – 16112 Wilaya d’Alger, Algérie

Téléphone/ Fax : 023-96-50-70

National and International Open Invitation to Tender

N° 02 DEN.PIPE.GBRS.TFT.GTP/2025

The National Company of Big Oil Works (ENGTP), presented by the Engineering Directorate issues a national and international open invitation to tender regarding:

The supply of:

- Batch 1: 6" PIPELINE, for the Project " EPC and commissioning for hook-up five acceleration wells for BRS phase 2 (blocks 433a & 416b-algeria) 

- Batch 2: 6" PIPELINE, for the Project " EPC for the connection of eleven (11) new wells to the existing collection network at TFT

The Tender Documents may be withdrawn from the above address, by every interested tenderer, in 21 days at most, as of the publication of this notice in BAOSEM, upon presentation of 'a nominative commitment on paper with company letterhead to the person authorized to withdraw and proof of payment of a non-refundable amount of:

30.000.00 DZD made in cash to the order of ENGTP at the cash desk located on the ground floor of the administrative building of GTP SIEGE/REGHAIA or by bank transfer to the account of ENGTP No. 002 00006 0600660203 22, Banque Extérieure d’Algérie BEA Agence Rouïba, Rue HASSIBA BEN Bouali Rouïba.

Or 200 Euros by bank transfer to the ENGTP account No. 001 00641 0310000031 74, Swift Code: BNALDZALXXX, Banque Nationale d’Algérie BNA Agence 641 ROUIBA, Rue HASSIBA BEN BOUALI ROUIBA-ALG.

The two-steps submission method applies to this invitation to tender.

concerning the first stage, the technical offers, without any indication of the price related to this invitation to tenders, must be submitted in three separate envelopes contained in the same envelope, at the following address:

A L’ATTENTION DE LA COMMISSION D’OUVERTURE DES PLIS (COP)

APPEL D'OFFRES NATIONAL ET INTERNATIONAL OUVERT

N° 02 DEN.PIPE.GBRS.TFT.GTP/2025

L’acquisition de La fourniture de :

- Lot 1 : PIPELINE 6’’, pour le Projet « EPC and commissioning for hook-up five acceleration wells for BRS phase 2 (blocks 433a & 416b-algeria) »

- Lot 2 : PIPELINE 6’’, pour le Projet « EPC pour le raccordement de onze (11) nouveaux puits au réseau de collecte existant à TFT »

OFFRE TECHNIQUE

 « NE PAS OUVRIR »

At the following adress:

LA COMMISSION D’OUVERTURE DES PLIS
ENGTP B.P. 09 – Zone Industrielle de Réghaia
16 112 Alger – Algérie

No later than 30 days as of the date of publication of this invitation to tender in BAOSEM.

Name and address of the Contracting Structure:

ENGTP / DIRECTION ENGINEERING / DEPARTEMENT PROCUREMENT

BP.09 Zone Industrielle de Réghaïa. 16112 – Wilaya d’Alger, Algérie.

TEL : 023-96-50-70 Poste 3250 / 3234

Fax : 023-96-50-70

E- Mail : ahalfaoui@engtp.dz / abouamra@engtp.dz /dendp@engtp.com

Technical offers are accompanied by an offer guarantee in the form of a Submission bail in the amount of:

Submission bail per Batch
Batch n° 01			Batch n° 01
DZD	Euros	Dollars US	DZD	Euros	Dollars US
2.000.000.00 DZD	15.000.00 €	15.000.00 $	5.000.000.00 DZD	35.000.00 €	35.000.00 $

The validity period of which is equal to the validity period of the OFFERS, i.e., (180) days as of the date of offer’s opening, in addition to an additional period of (30) calendar days.

The submission bail is an integral part of the technical offer.

The submission bail may be submitted to the offer’s opening committee by the tenderer or their authorized representative on the day the technical offers are opened.

The offers will be opened in the presence of the tenderers' representatives who so wish at the opening session at the above-mentioned address, the date of which will be communicated to them by invitation letter.

tenderers will remain engaged to their offers for a period of (180) calendar days as of the date of technical offers’ opening.

tenderers whose technical offers have been declared compliant will be invited to submit a financial offer.

The offers, during the second stage, will be opened in the presence of the representative(s) of the tenderers who wish to attend the opening session, which will be communicated to them by invitation letter.

Conditions of eligibility:

Tenderers must meet the qualification criteria to perform the contract based on the following criteria:

Manufacturer/Supplier experience in manufacturing and/or marketing the requested Supply in climatic conditions (the tenderer must provide at least three (03) certificates of satisfactory completion).

The tenderer must provide proof of their "API" certification, otherwise the offer will be rejected.

Be in a sound financial position and have sufficient liquidity or a line of credit to enable them to perform the contract without cash flow difficulties.

Professional references in the field.

The technical capacity and experience criteria will be used to determine whether the supplier has the capacity to perform the contract satisfactorily.

The tenderer will provide, by client name, professional references for contracts similar to those described in the Invitation to tender's documents that the bidder has successfully completed. Such references will include, at a minimum:

The client's name;

Locations and periods of services provided;

Certificates of satisfactory completion duly signed by the clients.

NB:

The references in points 1 and 2 must be provided in a document bearing the supplier's letterhead and signature.

Technical offers must be accompanied by the regulatory documents listed in the specifications.

And any other information or documents to be provided by bidders, if specified in the DAO. tenderers use, in particular, for this purpose, the corresponding documents and models included in the tender file.

The documents mentioned above are mentioned on the DAO in article IS: 7.2

Technical offers must contain the following documents:

The technical offer submission letter, according to the model attached to Section 4 of the specification;

The declaration to be submitted, according to the model attached to Section 4; of the specification;

The declaration of probity, according to the model attached to Section 4; of the specification;

The confidentiality declaration, according to the model attached to Section 4; of the specification;

The declaration of commitment, according to the model attached to Section 4; of the specification;

The bid guarantee (deposit) bearing minimum indications and equal to the Amount indicated in the table cited above and according to the model attached to Section 4: of the specification;

Denominated in Algerian Dinar and issued by a bank under Algerian law for tenderers under Algerian law;

Denominated in a convertible foreign currency and issued by a bank under Algerian law counter-guaranteed by a first-rate foreign bank for tenderers under foreign law;

The general information file and the administrative file, as detailed in points 10 and 11 below;

The technical offer itself, including the relevant documents of the Contract, in particular those highlighting the qualifications of the Bidder, its certifications, its approval, the execution plans and methodology, proposed technical solution and its experience;

The delegation(s) of powers of the signatory(s), and that(s) of the groups, authorizing the signatory(s) of the offer to bind the Bidder;

The commitment to provide the guarantee of the ultimate parent company or majority shareholders, if applicable;

Observations and/or comments on the technical offer in relation to the technical file, if applicable;

Observations and/or comments on the draft contract, if exists;

The draft contract signed and initialed in all its pages;

The authorization(s) of the manufacturer(s);

The DAO bearing, (section 1 to 2) on its last page, the words “read and accepted”;

And any other information or documents to be provided by the Bidders, if specified in the DPAO. For this purpose, Bidders use in particular the corresponding documents and models included in the DAO.

The documents mentioned - above are mentioned in the DPAO in article IS: 7.2

tenderers must accompany their technical offers with the following general information file:

The details of its organization and structure, including for each Member of a group or consortium;

Documents relating to his qualifications in the field of the Contract concerned as well as professional references;

Details of its current and forecast workload plan;

ISO certification or equivalent, company quality plan and/or qualification certificate;

Documents proving the qualifications and experience of key personnel;

Documents proving its financial, technical and production capabilities, necessary to execute the Contract;

tenderers must accompany their technical offers with the following administrative file:

for Algerian tenderers:

tenderers must submit their technical offers for each batch (batch 01 and batch 02) with an administrative file, including the following documents:

Company bylaws and list of principal shareholders or partners,

Extract from its electronic trade register;

Updated tax status in Algeria;

Extract from the audited tax roll for tenderers incorporated under Algerian law or foreign ones with a permanent establishment or having worked in Algeria

Status with regard to social security organizations in Algeria;

Certification of filing of company accounts

History of past and ongoing disputes;

Extract from the criminal record for individuals;

Financial situation of the Bidder, including balance sheets and income statements and the Auditor's reports for the past three years;

Power of attorney of the signatory authorized to act in the name and on behalf of the Bidder and binding the company or firm for the performance of the contract covered by these specifications. It must be original, dated, and signed by the bidder;

Professional references with certificates of proper execution of the supply covered by this call for tenders;

Manufacturer's authorization for the marketing of the supply covered by this call for tenders;

Payment receipt for the tender documents

For foreign tenderers:

tenderers must submit their technical offers for each batch (batch 01 and batch 02) with an administrative file, including the following documents:

Company bylaws and list of principal shareholders or partners, certified by the legal authorities of their countries;

Extract from its electronic trade register endorsed by the Chamber of Commerce; extract from the Kbis

Updated tax situation in the countries where their registered offices are located;

Certificate of social regularization;

Financial situation of the tenderer, including balance sheets and income statements and the Auditor's reports for the past three years;

History of past and ongoing disputes;

Extract from the criminal record for individuals;

Power of attorney of the signatory authorized to act in the name and on behalf of the bidder and binding the company or firm for the performance of the contract covered by these specifications. It must be original, dated, and signed by the tenderer; Professional references with certificates of proper execution of the supply covered by this Invitation to tender;

Manufacturer's authorization for the marketing of the supply covered by this Invitation to tender.

DAO payment receipt